FrontHandlebars, F forks, headlights, etc.

【Headlight】

“4.5 inch Bates Light Black General Purpose“

“SR Bottom Mount Light Stay“

〇It is installed with a headlight stay that is mounted low and close to the vehicle body.

【Front Fender】

“CHUCK BOX Front short fender Stainless steel for SR400/SR500“

◯A front fender made entirely of stainless steel. It is a carefully crafted handmade piece made from a chuck box.

【Handle/Handle Area】

“Street Low Handle Black“

◯ The handle is mounted low with a WM-made top bridge.

“Amal type throttle holder, general purpose (for 7/8″)“

“Amal type slot wire 1000mm ’88~’08“

“Brake wire/100mm 200mm 300mm 600mm SR400/500 #SR400/500“

“Clutch wire/300mm 200mm 100mm standard SR400/500 ALL YEARS“

〇 The handle is a Street Rover with a natural curve compared to the original. Simple throttle and long cables are used.

“MOTOR ROCK Decompression lever“

A decompression lever directly attached to the engine to simplify the area around the handle.

【Speedometer】

Mechanical speedometer φ48mm [No trip 1:4] General purpose #General-purpose parts」

CenterTank, oil tank, seat, step, muffler etc.

【Muffler】

『Slip-On Megaphone Muffler for SR400/500』

〇A megaphone muffler that is slip-on mounted on a normal exhaust pipe. It is one of the most prominent deep bass sounds among the many aftermarket mufflers.

【Seat】

◯One-off single seat. The rear frame is short and loop-processed.

【Electrical Equipment】

“Brat Style Electrical Plate“

〇A simple electrical plate that makes it easy to organize harnesses and electrical components.

“IC blinker relay wide range specification“

〇A wide-range blinker relay that can handle 1-150 watts without any problem, even for LED blinkers. It can also be used as a replacement for the original relay.

“Battery Lesser“

〇A battery-less kit that is made entirely in Japan.

【Gasoline Tank Installation】

◯ A gasoline tank with a modified base plate for Honda CB50, mounted with four rubber points. This makes the vehicle body slimmer.

“Welding nut non-through M8 2p“

〇 Drill a hole in the gasoline tank body, insert and weld. It’s non-penetrating, so it won’t leak. Used on both sides.

“Weld tab M size 4.5mm thickness 2p“

〇 Enlarge the hole diameter, change to rubber mount specification, and hold the non-penetrating nut. Used on both sides.

“Weld tab L size 4.5mm thick steel 2p“

〇 Used for the rear installation of the gas tank. Here too, the hole diameter is enlarged and used with rubber mounting.

【Engine Area】

“Breather filter SR400/500“

〇This is a filter kit needed when removing the original air cleaner.

【Drive System】

“Front sprocket SR400/500 428-19“

〇A durable replacement sprocket made of steel.

RearFenders, rear shocks, swingarms, etc.

【Rear Fender】

“Plain Aluminum Rear Fender with 120mm Width“

◯A universal aluminum fender with the same specifications as vintage British bikes (such as Triumph and BSA).

【Drive System】

“Rear sprocket SR400/500 428-56“

〇A durable sprocket made of steel.

“O-ring chain 428-130L“

〇A replacement drive chain with built-in O-rings.